Is it possible to interfacing Parallel RGB LCD on Colibri iMX6 / WEC2013?

Technical Support
, , ,
1

Hello,

I’m using Colibri iMX6 and I have to connect 5.6" 640x480 18bit parallel RGB LCD module.
According to “Display Driver Registry Settings” page Colibri module can only use 0(VGA) and 5(HDMI/DVI).
So is it impossible to interface parallel RGB LCD to Colibri iMX6 with WEC2013?

Best regards,

2

Dear smartek

The parallel LCD is even the default interface activated on the Colibri iMX6 modules.

I apologize the documentation is not precise. Actually it should read

[HKLM\Drivers\Display\Colibri]
Out=0       ; 0 - VGA on Apalis / Parallel LCD on Colibri

I’m just updating the documentation accordingly.

3

Dear andy
have you updated the documentation? if yes - please provide link
I am trying to connect Team source display 7" with CTP(I2C) with colibri Imx6 256MB.
Thanks and Regards
Anil KG

4

Hi @AnilKG ,
Yes, the documentation was updated, just follow the link above