Hello,
I have colibri VF61 with Viola carrier board.
I have flashed prebuilt Linux Image “Colibri_VF_LinuxImageV2.5” (from Toradex’s site) into 512MB NAND on VF61 SOM using SD card.
Now I want to setup Qt cross compilation environment on my Host machine (64 bit Linux 14.04).
**My requirements:
- I want to run simple Qt application (No Video, No Images, No Animation) on VF61. But also I want to use Qt5 only (not Qt4).
**My problems:
I referred some webpages “How to set up Qt Creator to cross compile for embedded Linux” .
Still it is not clear to me what exactly I need to do…
I have following questions for above mentioned webpage…
- For setting up Qt cross compile environment, do I need to built whole Linux image source code again with Qt???
- Nothing is mentioned about Qt source code downloading.
- Will final Linux with Qt image will fit into 512MB NAND flash?? (My requirement is mentioned above)
- I have to install bitbake. right???
Please give me some diirections about from where should I start like downloading particular source code etc.